The Hollow Wall Anchor’s low profile head allows for flush finishing.

The anchor’s large flange prevents the head from pulling into the substrate.

Anti-rotation barbs, incorporated in the flange, prevent the anchor from spinning in the hole.

Collapsing legs with an integral nut provide high strength and allow the screw to be removed without loosing the anchor inside the cavity.

1.Drill a hole to the recommended diameter. (HW10M4P may be hammered into plasterboard)

2.Tap the anchor into the hole until it is flush with the surface of the substrate.

3.Attach the setting tool to the head of the screw. Squeeze the trigger to expand the anchor. (Small sizes may be set using a screwdriver)

4.Remove the screw and place it through the fixture then back into the anchor. Tighten the screw until the fixture is fixed.