Epoxy Trowel Grade e131
|
Trowel Grade e131 is a two part structural repair mortar and adhesive based on a blend of epoxy resins and high quality fillers, it is moisture tolerant and offers excellent adhesion to concrete, metal and a wide range of substrates. |
SPECIFICATIONS
Properties |
Typical Value |
Appperance |
Light Grey |
Solids Content |
100% |
Mixing proportions by weight |
1 Hardener:2 Resin
|
Compressive Strength |
69 MPa |
Tensile Strength |
15 MPa |
Flexural Strength |
30 MPa |
Installation Temperature |
+4°C to +35°C |
Working Time
|
± 30minutes @ 20°C |
Heat Distortion Temperature |
Approx 65°C |
|
|
FEATURES & BENEFITS
• 100% solids epoxy – solvent free, No VOC. • High compressive strength. • Low viscosity – easy application. • Moisture tolerant. • Good chemical resistance – long term protection. • Non Shrink • High strength adhesive - excellent adhesion to most construction materials. • Non sag in vertical applications
• Concrete components - repairs and bonding • Steel, Iron, Marble, Granite, Ceramic • Paving slabs, Cobblestones • Masonry, Bricks, Mortar
|
|
INSTALLATION GUIDE
Refer to the Technical Data Sheet and MSDS for further detailed installation instructions and precautions.
- Concrete must have a minimum of 7 days cure. Surface must be clean, sound, dry and free from
any loose coatings/particles or surface contaminates such as grease, oil, chemicals, paint, rust or curing membranes
- For best results, ensure the components are between +5°C and + 29°C prior to mixing. Premix both
components separately to a homogenous consistency. Place the correct proportion of Component A and Component B into a clean container with flat wall and bottom.
- It is recommended where possible to always use whole units.If part units are required then accurately measure by weight.
- Mix thoroughly for a minimum of 3 minutes using a low speed drill (450-600 rpm) and a mixing paddle. Keep the paddle below the surface material to avoid entrapment of air. After 3 minutes, carefully scrape the sides and bottom to ensure thorough mixing, then continue to mix for a further 2 minutes until a uniform light grey colour is achieved.
- When applying as a thin layer adhesive use a spatula or notched spreader or trowel. When applying as a repair mortar use a trowel or gloved hand to a smooth finish.Ensure good contact with the surface is achieved.
- On vertical surfaces maximum layer thickness is 15-20mm to prevent slumping. To avoid potential shrinkage caused by exotherm the maximum layer thickness per application is 40mm
|
|
TECHNICAL DATA & DOCUMENTS
PRODUCT INFORMATION
|
TECHNICAL INFORMATION
|
|
|
|
|